MikroTik RB2011UiAS-2HnD-IN 2.4GHz 5xLAN 5xGb SFP 802.11bgn LCD L5

The RB2011 is a low cost multi port device series. The RB2011UiAS-2HnD-IN is designed for indoor use, and available in many different cases, with a multitude of options. 

The RB2011 is powered by RouterOS, a fully featured routing operating system which has been continuously improved for fifteen years. Dynamic routing, hotspot, firewall, MPLS, VPN, advanced quality of service, load balancing and bonding, real-time configuration and monitoring - just a few of the vast number of features supported by RouterOS. 

RouterBOARD 2011UiAS-2HnD-IN has most features and interfaces from all our Wireless routers. It’s powered by the new Atheros 600MHz 74K MIPS network processor, has 128MB RAM, five Gigabit LAN ports, five Fast Ethernet LAN ports and SFP cage (SFP module not included!). Also, it features powerful 1000mW dual chain 2.4GHz (2192-2732MHz depending on country regulations) 802.11b/g/n wireless AP, RJ45 serial port, microUSB port and RouterOS L5 license, as well as desktop case with power supply, two 4dBi Omni antennas and LCD panel- all this for only $129! 

Tested and recommended to use with MikroTik SFP modules: S-85DLC05D, S-31DLC20D and S-35/53LC20D (not included).

RouterBOARD 2011UiAS-2HnD-IN comes with desktop enclosure, LCD panel and power supply. 

Wall mount kit (product code RBWMK) for network closet is available for purchase as an optional accessory.

The RB2011Ui also has passive PoE output capability on the last port (ETH10), this means you can power another device just by connecting it over regular Ethernet cable.

Wireless specifications

wireless parameters may be limited in software, depending on your local regulatory limitations

Ethernet test results

• All tests are done with Xena Networks specialized test equipment (XenaBay),and done according to RFC2544 (Xena2544)


• Max throughput is determined with 30+ second attempts with 0,1% packet loss tolerance in 64, 512, 1518 byte packet sizes


• Values in Italic indicate that max throughput was reached without maxing out CPU, but because board interface configuration was maxed out


• Test results show device maximum performance, and are reached using mentioned hardware and software configuration, different configurations most likely will result in lower results